Skip to main content
Tankless Water Heaters · Frisco, TX

Tankless Water Heater Service in Frisco, TX

The City of Frisco publishes its own fact sheet on tankless water heaters, and it covers the issues we see most: gas supply, venting, scale and freezing. Whether your Frisco home came with a tankless unit or you’re replacing a tank, we install, descale and repair gas tankless heaters, and we handle the Frisco permit.

Texas Master Plumber #M-17697 · Family-owned since 1990 · Open 24/7

Quick Answer

Frisco’s “Simple Facts about Tankless Water Heaters” notes that a 50-gallon tank heater uses around 40,000 Btu, while a tankless unit can use up to 199,000 Btu, so the gas piping may need changes. Type B vent can’t be used for most tankless heaters. Frisco’s NTMWD water, which the city calls moderately hard, builds scale in the heat exchanger, so many manufacturers recommend yearly maintenance.

Texas Master Plumber #M-17697 · 24/7 emergency service · Flat-rate written estimates
License M-17697 Family-owned since 1990 Tankless install and repair 24/7 emergency service Flat-rate written estimates

Hard freeze on the way?

If your tankless unit is mounted outside, Frisco’s fact sheet says most manufacturers recommend turning it off during long freezes and letting a little water drip from hot-water faucets. Check your unit’s manual first. If you smell gas, leave and call 911, then CoServ Gas (844-330-0763) or Atmos Energy (866-322-8667), whichever is on your bill. For tankless trouble, call us at (682) 284-0966.

Frisco’s fact sheet says tankless heaters are becoming more popular in new construction and are an option when a tank wears out. In a city where most homes are less than 25 years old, we see both: newer houses with a tankless unit that needs scale removal or a repair, and 2000s houses swapping an aging tank for tankless.

Have a tank heater? See water heater repair in Frisco or water heater replacement in Frisco. For a gas smell, see gas leak repair in Frisco.

Newer Frisco homes, two tankless situations

The Census (ACS 2020–2024) gives Frisco a median home build year of 2009, and about 81% of homes were built in 2000 or later. That splits Frisco’s tankless work in two. Owners of 2000s homes are often replacing an original tank. In 2010s and newer homes that already have tankless, the work is mostly maintenance and repairs.

2009
median year a Frisco home was built
~81%
of homes built 2000 or later
199,000
Btu a tankless unit can use, per Frisco

Frisco tankless work by era

Before 2000

Older Frisco

About 19% of homes. Conversions here need the most gas line and vent work.

2000s

The growth years

About 35% of homes. Original tanks are now 15 to 25 years old, which is when many owners consider switching.

2010s

Peak building years

About 40% of homes. Some came with tankless, and those first units are now due for regular descaling and occasional parts.

2020–today

Newest neighborhoods

About 7% of homes. Mostly maintenance and getting owners set up with a descaling routine.

What Frisco’s tankless fact sheet says

City of Frisco, “Simple Facts about Tankless Water Heaters”

  • Gas supply: a 50-gallon tank uses around 40,000 Btu; a tankless unit can use up to 199,000 Btu. The fix may be larger gas piping, or a higher-pressure system with regulators near the unit.
  • Venting: condensate in the vent can be highly acidic and corrosive. Type B vent can’t be used for most tankless heaters, and fan-pressurized vents need better seals.
  • Maintenance: hard water deposits build up in the heat exchanger, and many manufacturers recommend annual maintenance with an approved solution run through the coils.
  • Thermal expansion: a tankless unit heats water only on demand, so it doesn’t need thermal expansion control.
  • Permits: the city says any water heater replacement should be done by a licensed plumber with a permit for city inspection.

Staggs Plumbing is registered with the City of Frisco and pulls the permit itself. When a permit is pulled for work on an existing home, Frisco also requires a carbon monoxide alarm.

Frisco water and tankless maintenance

Frisco buys treated water from NTMWD’s Wylie plant. The city’s 2025 report calls the water moderately hard and lists total hardness of 96 to 200 ppm, about 5.6 to 11.7 grains per gallon.

1

Isolate

We close the service valves so the unit is cut off from the house plumbing.

2

Flush

A pump circulates descaling solution through the heat exchanger for the time the manufacturer specifies.

3

Clean

We rinse the unit and clean the inlet screen.

4

Check

We restart the unit, check its flame and flow, and report how much scale came out.

Tankless repairs we handle in Frisco

Problem Likely cause Repair
Error code after a freeze Frozen or cracked heat exchanger or piping Inspect and replace damaged parts
Weak or fluctuating flow Scaled heat exchanger or a clogged inlet screen Descale and clean the screen
Burner shuts down mid-shower Gas pressure, flame sensor or a vent problem Measure gas pressure; test parts; inspect the vent
Fan runs but no ignition Igniter, gas valve or control board Diagnose and replace the failed part
Corrosion near the vent Wrong vent material or a failed seal Replace with the manufacturer-listed vent

Switching a Frisco home from tank to tankless

  • Gas sizing first. We total your appliances and check pipe size and pressure before quoting.
  • New vent. We remove the Type B vent and install the manufacturer-listed vent.
  • Condensate drain. Condensing units need a drain line, usually with a neutralizer.
  • Service valves. We install isolation valves so future descaling is simple.
  • Permit, CO alarm and inspection. Handled with the Frisco permit.

Tankless trouble or a switch? Start here.

A few things to check or gather:

  1. Note any error code on the display.
  2. Check power to the unit and its GFCI outlet.
  3. Confirm the gas is on to other appliances.
  4. Find the brand and model on the unit’s data plate.
  5. Call (682) 284-0966 for service or a written conversion price.
Water leaking from an outdoor unit after a freeze? Shut off the cold-water valve to the unit and turn it off until it’s inspected.

Frisco neighborhoods we serve

We serve all four Frisco ZIP codes, 75033, 75034, 75035 and 75036, from the Rail District to the newest neighborhoods in the north and west.

We’re based in Plano, just south of Frisco.

Frisco tankless water heater FAQ

Can my existing gas line handle a tankless heater?

Maybe not. Frisco’s fact sheet notes a tankless unit can use up to 199,000 Btu compared with about 40,000 for a 50-gallon tank. We check your gas load before quoting.

Can I reuse my tank’s vent?

Usually not. Frisco says Type B gas vent can’t be used for most tankless heaters because condensate is corrosive and the vents are fan-pressurized.

Does a tankless unit need an expansion tank?

No. Frisco’s fact sheet says tankless units heat water on demand, so they don’t need thermal expansion control.

How do I protect an outdoor unit in a freeze?

Most manufacturers recommend turning it off and letting a small amount of water drip from hot-water faucets during long freezes. Follow your unit’s manual.

Is a permit required?

Yes, for a water heater replacement. Frisco also requires a carbon monoxide alarm in an existing home when permitted work is done.

How often should I descale in Frisco?

Many manufacturers recommend annual maintenance. With Frisco’s moderately hard water, once a year is a sensible schedule.

Built for Frisco’s newer homes.

Tankless water heater service in Frisco, TX

Staggs Plumbing is a family-owned, licensed Texas master plumber (License #M-17697) serving North Texas since 1990. We size the gas and vent, pull the Frisco permit, and give you a written flat-rate price first.

Call (682) 284-0966

What Our
Customers Say

"Great price! Staggs Plumbing was incredible - they replaced our entire system from cast iron to PVC in less than 3 days, with no cut corners and incredible attention to detail. Their prices were fair, communication was incredible, and they even took care of some dry wall replacement at no cost to us after the job was done.. we are so pleased and will for sure call Staggs anytime in the future!"
"A little miscommunication up front regarding messages left over the past weekend but the Plumbers showed up as scheduled. They did a great job and were very professional as always. Pleased with their repairs and a fair price."

Real results from every plumbing project.

24/7 Emergency Service

We're available day and night to handle urgent plumbing issues.

Flexible Scheduling

Choose a time that fits your schedule — we work around your convenience.

Get In Touch

"*" indicates required fields

Date (optional)