Skip to main content
Water Heater Repair · Garland, TX

Water Heater Repair in Garland, TX

Garland’s water comes from the North Texas Municipal Water District, and the City of Garland calls it hard. That shows up as scale in the tank, white flakes in your faucet screens and a heater that rumbles. We find the actual fault, put the price in writing first, and handle Garland’s permit and inspection if the heater has to be replaced.

Texas Master Plumber #M-17697 · Family-owned since 1990 · Open 24/7

Quick Answer

Garland Water Utilities buys all of its treated water from the North Texas Municipal Water District (not Dallas Water Utilities). The city says the water is hard, averaging 161 mg/L, or 7.0 to 10.5 grains per gallon. Most Garland water heater repairs involve scale and sediment, a failed thermostat, element, igniter or gas valve, or a worn relief valve. If the tank itself leaks, it has to be replaced, and Garland requires a permit and inspection for every water heater replacement.

Texas Master Plumber #M-17697 · 24/7 emergency service · Flat-rate written estimates
License M-17697 Family-owned since 1990 Gas and electric heaters 24/7 emergency service Flat-rate written estimates

Water on the floor around the heater?

Shut the cold-water valve on the inlet pipe at the top of the heater. For a gas heater, turn the control knob to OFF; for an electric heater, turn off its breaker. Don’t touch water coming from the relief valve; it can scald. If you smell gas, leave the house and call 911 and Atmos at 866-322-8667. Our Garland gas leak page covers that. Then call us at (682) 284-0966.

Garland runs its own water utility, with about 1,850 miles of pipe, but it doesn’t treat lake water itself. All of Garland’s drinking water is bought already treated from NTMWD, which draws from Bois d’Arc Lake, Lavon Lake, Jim Chapman Lake, Lake Tawakoni, Lake Texoma and the East Fork wetland, with Lavon Lake as the main source. The minerals in that water are what a Garland water heater has to deal with every day.

Is it time for a new heater? Compare water heater replacement with going tankless. Water spreading fast? See emergency plumbing in Garland.

Garland’s 1970s housing and the heaters in it

The Census (ACS 2020–2024) counts about 86,200 homes in Garland, with a median build year of 1978. About 55% were built before 1980, and the 1970s alone account for 28%, the largest share of any decade. About 68% are single-family detached houses. In a house built in the 1970s, the closet or garage corner, the vent and the connections were laid out for a heater installed more than 45 years ago.

161 mg/L
Garland’s average hardness, per the city
1978
median year a Garland home was built
~28%
of homes built in the 1970s

What Garland heaters look like by era

1950s–60s

Postwar Garland

About 26% of homes, built as the city grew from 10,571 people in 1950 to 81,437 in 1970. Heaters in interior closets often need the combustion-air openings and venting checked.

1970s

The biggest decade

About 28% of homes. Garage installs are common, and Garland requires a garage heater to be raised when an electric heater’s ignition source is under 18 inches off the floor or the manufacturer calls for it.

1980s–90s

Firewheel and the north

Firewheel Golf Park opened in 1983, and the north side filled in around it. Attic heaters are more common here, and Garland has specific access rules for them.

2000–today

Newest homes

A smaller share, including homes near Firewheel Town Center (2005). Some use tankless units, which need descaling in Garland’s hard water.

What Garland’s water does to a water heater

Garland water: the city’s own facts

  • Supplier: Garland Water Utilities, owned by the City of Garland. It buys all of its treated water from NTMWD.
  • Hardness: the city calls Garland’s water hard. Its FAQ gives an average of 161 mg/L, or 7.0 to 10.5 grains per gallon, varying month to month. The 2025 water quality report lists a range of 96 to 200 ppm.
  • White particles in faucets: the city says these may be calcium carbonate scale from your water heater, made worse when the thermostat is set too high, and that you probably need to flush the heater.
  • Anode rods: the city’s FAQ also notes that every tank has an anode rod that slowly wears away while protecting the tank. Once it’s gone, the tank starts to corrode.

Those are the three things we look at first on a Garland service call: how much scale is in the tank, where the thermostat is set, and how much is left of the anode rod.

Water heater repairs we make in Garland

Symptom What’s usually behind it Repair
White flakes in aerators Calcium carbonate scale from the tank Flush the tank and check the thermostat setting
Rotten-egg smell from hot water A reaction with the anode rod Replace the anode with one suited to the water
Rumbling, slow to heat Sediment layer on the tank bottom Flush it; replace the tank if it’s too far gone
Pilot or burner won’t stay lit Thermocouple, igniter or gas control valve Test and replace the failed part
Electric heater runs lukewarm Scaled or burned-out element, or a bad thermostat Replace the element or thermostat
Relief valve drips or sticks Overheating, high pressure or a worn valve Find the cause and replace the T&P valve

Garland’s rules when a water heater is replaced

What the City of Garland requires

  • Permit and inspection: Garland requires a permit for water heater replacement and an inspection of all completed work. An adult must be present for the inspection.
  • Who pulls it: a state-licensed master plumber registered with the City of Garland, or a homeowner who owns, lives in and has a homestead exemption on the home (verified through the Dallas Central Appraisal District).
  • Every heater: a T&P valve that works when the inspector lifts it, a drain line of at least 3/4-inch copper or CPVC ending on the garage floor or outdoors, a shutoff on the cold-water line and a pan.
  • Gas heaters: a gas shutoff within 6 feet in the same room, double-wall Type B vent through the attic with 1-inch clearance from combustibles, and combustion air for closet or small-room installs. A gas heater in a bedroom or bathroom must be in its own closet with a weatherstripped solid door.
  • Attic heaters: within 20 feet of the access, reached by permanent stairs or a 300-pound pull-down ladder, with a 24-inch solid-floored walkway, a 30-by-30-inch work platform, a switched light and a pan drained outside.

Staggs Plumbing is registered with the City of Garland and pulls the permit itself, so you don’t have to file a homeowner’s affidavit. Because the inspector checks the whole installation, we look at the venting, gas shutoff and combustion air before we give you a replacement price.

How a Garland repair visit works

1

Check

We look at the tank, burner or elements, relief valve, venting and gas or electric supply, and read the data plate.

2

Explain

We show you what failed and give you a written flat-rate price before any work.

3

Repair

Most part replacements and flushes are done on the same visit when we have the part.

4

Replace if needed

A leaking tank gets replaced under a Garland permit and inspected by the city.

When repair stops making sense

  • The tank is leaking. A leak from the tank body can’t be patched; the heater needs replacing.
  • The anode is long gone and there’s rust in the hot water. The tank is already corroding from the inside.
  • The heater is old and needs a costly part. We’ll show you both prices so you can decide.
  • The closet or attic setup no longer meets Garland’s rules. Those items have to be corrected anyway when the heater is replaced.

Water heater trouble in Garland? Start here.

Go through this list:

  1. Water leaking? Close the cold-water inlet valve at the top of the heater.
  2. Turn the heater off: gas control to OFF, or the breaker off for electric.
  3. Gas smell? Leave the house first, then call 911 and Atmos at 866-322-8667.
  4. Flakes in the faucets but hot water is fine? It’s likely scale. Not an emergency, but book a flush.
  5. Call us at (682) 284-0966 for a diagnosis and written price.
Relief valve releasing hot water or steam? Shut off its gas or power, then phone us. Don’t cap or plug the valve or its drain line.

Garland neighborhoods we serve

We serve Garland ZIP codes 75040, 75041, 75042, 75043 and 75044 and the Garland part of 75048: downtown and South 11th Street, the neighborhoods along Duck Creek, the 1970s subdivisions in the middle of the city, Firewheel and the Lake Ray Hubbard side.

Garland sits between our Plano headquarters and our Rockwall branch.

Garland water heater FAQ

Who supplies Garland’s water?

Garland Water Utilities, a city-owned utility. It buys all of its treated water from the North Texas Municipal Water District, whose main source is Lavon Lake. Garland is not served by Dallas Water Utilities.

Is Garland’s water hard?

Yes. The city says it’s hard, averaging 161 mg/L, or 7.0 to 10.5 grains per gallon. The 2025 water quality report lists 96 to 200 ppm.

What are the white bits clogging my faucet screens?

According to the City of Garland, they may be calcium carbonate scale from your water heater, often worse when the thermostat is set too high. Flushing the heater usually helps.

Why does my hot water smell like rotten eggs?

Usually a reaction between the water and the tank’s anode rod. Replacing the anode with a different type often fixes it. Don’t just remove the anode; it protects the tank from corrosion.

Do I need a permit to replace a water heater in Garland?

Yes. Garland requires a permit and an inspection of the finished work. A city-registered master plumber pulls it, or a homeowner with a homestead exemption can pull it with an affidavit.

My water heater is in the attic. Can it be replaced there?

Usually. Garland requires the heater to be within 20 feet of the attic access, with permanent stairs or a rated pull-down ladder, a solid walkway, a work platform, a light and a pan that drains outside. We check those before quoting.

Hard water. Straight answers.

Water heater repair in Garland, TX

Staggs Plumbing is a family-owned, licensed Texas master plumber (License #M-17697) serving North Texas since 1990. We find what’s wrong, give you a written flat-rate price first, and pull the City of Garland permit when a heater needs replacing.

Call (682) 284-0966

What Our
Customers Say

"Great price! Staggs Plumbing was incredible - they replaced our entire system from cast iron to PVC in less than 3 days, with no cut corners and incredible attention to detail. Their prices were fair, communication was incredible, and they even took care of some dry wall replacement at no cost to us after the job was done.. we are so pleased and will for sure call Staggs anytime in the future!"
"A little miscommunication up front regarding messages left over the past weekend but the Plumbers showed up as scheduled. They did a great job and were very professional as always. Pleased with their repairs and a fair price."

Real results from every plumbing project.

24/7 Emergency Service

We're available day and night to handle urgent plumbing issues.

Flexible Scheduling

Choose a time that fits your schedule — we work around your convenience.

Get In Touch

"*" indicates required fields

Date (optional)